FINISHING
Before the work, eg painting, wallpapering, tiling, is started, should be checked if the surface is suitable.
The surface and joints must be dry and dust-tight, with no stains.
One should particularly note the following:
that splashes plaster, cement e.d. removed
scratches and damaged areas, etc. should be leveled with Megapan® + insert finish
all grouted areas are sanded smooth and possibly slightly
the plate, and the joints grouted sections over the entire surface dry
that dust is carefully removed
The moisture content of the Megapan® sheets must be less than 1.3% amounts to. Therefore, for 48 hours before the humidity was higher than 70% and the air temperature is not lower than 15 ° C.
Painting
The smooth side of the plate Megapan® is suitable for dyeing. All the usual paints are used such as latex, dispersion or enamel paint. Paints contain minerals such as calcium silicate and can be used if instructed by the manufacturer are suitable for Megapan® surface.
For latex paints should be given the opacity. The paint, according to the manufacturer's instructions in at least two layers.
Paper
All kinds of wallpaper, textured wallpaper can be applied by conventional wallpaper paste. A special coating is required.
Patch structure, crepi
Structure plaster is applied to the rough side, but the joints should be reinforced with additional reinforcement tape.
Tiles
The Megapan® sheets can all tiles and slabs of ceramic material and plastic easily be applied to an adhesive Bonding systems. Each dispersion, reaction resin and plastic glorified cement powder adhesive is suitable as the manufacturer specified. A primer is needed if the tile adhesive manufacturer's advice. The gluing is done on the rough side of the plate.
Veneer quality films and coatings and laminates
The Megapan® sheet can be veneered with veneer, laminates and foils. The stability of the adhesive bonding primers can be significantly improved.
Before applying the adhesive should have a number of cabin linings to be made.
