USE & INSTALLATION

USAGE

MEGAPAN is mainly used in partition and ceiling . The board features fireproof , waterproof , convenient processing , high intensity and free from erosion . Those leave the larger design space for designer and can replace traditional constructionboards .It is very suitable for interior and exterior construction and decoration board in single-family homes ,appartment complexes, commercial high-rise buildings, theaters, schools, museums, hospitals, retail, hotels, restaurants, pubs, airports, subway stations, tunnels, fire separations, fireproof doors, mobile foors,bill-boards etc...

APPLICATION RANGE

THICKNESS	CEILING	PARTITIONS	OUTSIDE WALL	SURFACE	FIRE PROOF DOOR	ROOF LINING BOARD
3 mm				*	*	*
5 mm	*	*	*	*	*
6 mm	*	*	*	*	*
8 mm	*	*	*	*
9 mm	*	*	*	*
10 mm	*	*	*	*
12 mm	*	*	*	*

INSTALLATION

Verify whether site conditions are acceptable for installation .
Do not proceed with installation until unacceptable conditions are corrected .

METHODS:

MEGAPAN may be scored and snapped ,cut , trimmed, drilled or shaped using ordinary power and hand tools.
MEGAPAN may be fastened to supporting joists using self-drilling , self-countersinking, corrosion protected cement board screws .
Fasteners should be placed at 305mm interval along edges.
Spacing may be increased to 450mm at intermediate joists.
The screw need to sink into the face of the board up to 0.5mm.

The smooth side of MEGAPAN is suitable for painting or wallpapering with no futher preparation.
The rough side is suitable for application of ceramic tile.
Either solvent based oil paint or water based latex paint can be used .If the panels are to be directly exposed to rain and
weather , apply a prime coat of acrylic-siloxane waterproofing
sealer, followed by oil based paint.

Where MEGAPAN is to be used as a mounting surface for ceramic tile ,such as in a bath or shower enclosure , a solvent based tile mastic is recommended.

MEGAPAN recommended assemblies consist of exterior wall, interior wall ,shaftwall ,steel column , staircase , ceiling/Floor and roofing.Recommended installation methods for each application can be asked for.

Filling and finishing systems ( partition walls / ceiling )
One can either glue or use plaster to finish off the joints

PRECAUTIONS:

Avoid handling MEGAPAN panels when being wet .Alow to dry before applying joint finishing materials.
Use appopriate setting compounds during cold weather or when slow drying .
MEGAPAN does not contain any known cancer causing material.It
is free of dust but it is recommended during machining and cutting and sanding operations to use a mask .
Use of gloves is suggested to reduce the possibilty of abrasion injuries .
Do not install srews on 45 degree angles at corners.
Board ends must be supported by joists.
Fasteners must always be installed over supporting structure .
Do not install surface coverings by driving screw fasteners, except over supporting structure .

Fasteners should not be closer than 15mm-20mm from any edge.

For more info, see the product page